IC694MDL310
The GE Fanuc IC694MDL310 for the Rx3i is an Output Module installed in any I/O slot in the Rx3i system. It has a rated voltage of 120 volts AC and an output current of 0.5 Amperes per point.
About
The GE Fanuc IC694MDL310 Output Module has a rated voltage of 120 Volts AC and an output voltage range of 85 to 132 Volts AC at a frequency of 50/60 Hertz. The module has 12 output points, which are divided into two isolated groups of six points. The two groups are safeguarded with a 3 Amperes fuse. The output points are used on separate AC supply phases or powered from the same AC supply. Every output has an RC snubber that offers protection against transient electrical noise. The GE Fanuc IC694MDL310 Output Module has an inrush current of 5 Amps maximum for one cycle to offer with a high degree with up to 10X the rated current to enable the outputs to control a wide selection of incandescent and inductive loads.
The GE Fanuc IC694MDL310 Output Module only works with an AC power source, but cannot operate with a DC power source. It has numbered LEDs that indicate the ON/OFF status of every output point of the module. In case an output fuse blows, the LED (f) in color red turns on. The red bands indicate that IC694MDL310 is a high-voltage module that can be installed in any I/O slot in the Rx3i system. It has extended terminal blocks that offer shroud depth required by AC devices for field wiring. The GE Fanuc IC694MDL310 Output Module can be used with Spring-style, Extended Spring-style, Box-style or Extended Box-style. If your module is not working, you may need to take if for repair.