IC694MDL390
The GE Fanuc IC694MDL390 module from the RX3i PacSystem series is an Output Module installed in any I/O slot in the Rx3i system. The module has a rated voltage of 120/240 Volts AC.
About
The GE Fanuc IC694MDL390 Output Module from the RX3i PacSystem series has a rated voltage of 120/240 Volts AC, an output current of 2 Amperes per point, an inrush current of 25 Amperes per cycle and output voltage range starting from 85 to 264 Volts AC at a frequency of 50/60 Hertz. This module has 5 output points, and every point has a different common. The output circuits can either be used on separate AC supply phases or used from a single power supply. The AC supply used to run the loads linked to the outputs should be user-supplied. This module can only be operated using AC power supply and cannot be powered using a DC power supply. The GE Fanuc IC694MDL390 Output Module has a 3 Amperes fuse on each output. It comes with an RC snubber to secure all the outputs from electrical transient on power lines.
The GE Fanuc IC694MDL390 Output Module contains labeled LEDs that indicate the ON/OFF of all output points. Besides, it has a red LED (F), which in case the output fuse blows, it turns ON. The red band at the top of the module shows the Fanuc IC694MDL390 Output Module is a high-voltage. This module has an operating temperature between 32 to 140 degrees F and a storage temperature between -40 to 185 degrees F. It has a non-condensing humidity of 5% to 95%. The module shock resistance of 15G, 11ms as per IEC60068-2-27, JISC0912 standards and vibration of 10 – 57 Hz, 0.0524 mm (0.006 in) displacement peak as per IEC60068-2-6, JISC0911 standards.